Study

CTE- What is it good for???

  •   0%
  •  0     0     0

  • Who is the 6th grade Vice Principal this year?
    Mr. Hand
  • What are some of the units that the Imperial System of Measurement uses to measure length.
    inches, feet , miles , fractions of inches
  • Who said "Education is not the learning of facts but the training of the mind to think"?
    Albert Einstein
  • What units of measurement does the Metric System of Measurement use to measure length?
    millimeters, centimeters, meters, kilometers
  • On our wooden and plastic classroom rulers, what is the smallest fraction the inch is divided into?
    1/16
  • Name one of the two day time custodians who keep our school clean and running smooth.
    Ms. Randolph and Mr. Smith
  • What was the safety expectations contract that you and your parents had to sign called?
    The Standards of Workmanship
  • What are the first things you should do when you enter the classroom for Engineering Exploration every day?
    1. Sit in your seat, 2. Open computer, go to schoology, 3. Find the warm-up for the day 4. complete warm-up
  • What famous structure can you find in picture of in this classroom?
    Eifel Tower
  • What is the 6th step of the design process?
    Construct your design- Its on the poster in the front of the room
  • What teacher do you line up with in the event of an evacuation drill (fire drill)?
    Hawk Talk teacher
  • What is our next project called that we will start tomorrow?
    Rube Goldberg
    All Wound Up
    Traversing the Terrain
    Up Up and Away
  • Who is the UMS principal?
    Mr. Kibler
  • What is the NASA rover that landed and explored on Mars called?
    Curiosity
  • Name the high school did Mr. Lowrie graduate from? Also name one of the two colleges that Mr. Lowrie graduated from
    Linganore High School and Flagler College or Frostburg State University
  • What percentage of your grade in this class comes from "Checkpoint" grades?
    70%
  • How many millimeters are in 27 CM?
    270 mm
  • What are the thin, solid lines with arrowhead on each end that show a measurement on a technical drawing.
    Dimension lines