WHAT TOOL THAT WE USE?

Mason is joining two metal pieces together permanently. Which machine should he use?

David is fixing a wooden crate. He has nails but needs a tool to drive them into the wood. Which tool should he use?

Michael is working on an electrical wire. He needs to twist and cut the wires, but his hands aren’t strong enough to do it alone. Which tool should he pick?

Zoe is shaping a metal block by cutting grooves and slots into it. She needs a machine that can move the workpiece in multiple directions while cutting. What machine does she need?

Daniel needs to cut a metal pipe to a specific length. He wants a manual tool for this task. Which tool is best for him?

Lucas just cut a metal sheet, but the edges are rough and sharp. He needs to smooth them down for safety. What tool should he use?

Mason is shaping a piece of metal by hammering it. He needs a strong surface to support his work. Which tool is best?

Chloe needs to make a hole in a steel plate to attach a bolt. Which machine should she use?

Emma is repairing a wooden chair. One of the screws holding the seat is loose, and she needs to tighten it. What tool will help her do the job? by hand. He needs a tool that can grip and rotate the bolts securely. Which tool should he use?

John is assembling a metal frame, but some of the nuts and bolts are too tight to turn by hand. He needs a tool that can grip and rotate the bolts securely. Which tool should he use?

Sophia is carving a decorative pattern on a wooden block. She needs a tool that can remove small pieces of wood precisely. Which tool is best for her?

Henry has a thick metal bar that needs cutting quickly, but a hacksaw will take too long. Which power tool should he use?

Leo is gluing two wooden boards together and needs to hold them tightly until the glue dries. What tool should he use?

Olivia is working in a machining workshop and needs to measure the diameter of a small rod with extreme accuracy. What tool should she use?

Ethan is sharpening a chisel that has become dull. He needs a machine that can grind its edge back to sharpness. What tool should he use?