Share MSSC Indicator Measurement
Save to Folder
Image magnification is used in what type of device?
Optical comparator
Indicators and optical comparators are two examples of how to perform __________ comparison measurements.
Indirect
Which of the following measurement devices is a direct comparison measurement tool?
Micrometer
The indicator shown has been mastered using a part that measures 4.500 inches in length. What is the actual length of the part shown?
4.515 inches
Which dial indicator component enables the indicator to be zeroed to a reference dimension?
Bezel
Gauge blocks come in varying accuracies in tolerance, also known as __________, with 0.5 being the most precise.
Grades
When mastering an indicator, it is important that the part used as the master to be placed __________ as the parts to be measured.
in the same position
The last step in measuring a part using indirect measurement states you need to add the master length to?
the dial indicator reading
When measuring a part that is shorter than the reference, the final length is determined by subtract the value of the indicator reading from?
the master part length
What is a gauge fixture designed to do? Accurately position the part and assure that the measurement is always taken from __________.
the same reference point
A device that is always used as a reference surface is a:
Surface plate
A __________ provides a very accurate finished base on which to measure parts.
Surface plate
Although surface plates can be made from other materials, __________ is the most popular due to its physical properties.
Granite
The date due for calibration must appear on the calibration label of __________.
Measurement and test equipment
